Does NOT WORK ON JEEP ECO DIESEL!
Other oil coolers might be needed.
This cooler supplied is for race use only!
Bigger Coolers are needed for other application!
Worried about Oil cooler failure?
Do you tow and find yourself having high oil temps?
Do you live in a hot climate and needing to drop your oil temps when daily driving?
Well here is your solution!
This is are fully in house built oil cooler units! Remove your factory cooler that has been known to go out and separate the oil and coolant away for each other. This kit not only Helps drop those oil temps on daily driving but also adds in a extra 3+ quarts of oil to your system "depending on the set up!"
In our testing with a all stock eco diesel ram we found in the high 90's out side temp daily driving oil temps stay under 200 degrees. "super cooler set up"
Later in our tow testing ambient temps of 99-100 degrees out side, towing 11k at avg speed of 65 mph the highest oil temp reached was in mid- high 230's.
Base line testing was daily driving 215-220 and towing in the same conditions was all the way into the 250-260's.
The over all avg is a 20 degree drop in oil temps. Cooler is rated at 250 psi. Lines rated to 600 psi.
RACE COOLER SET UP IS SMALLER COOLER, BIGGER COOLERS REQUIRE CUSTOM FITTING!
1 - Water jet cut oil cooler bypass plate.
2 - High end stainless Braided lines. With -10 AN fittings installed.
1 - Front mount oil cooler with install brackets. 10x13x2
1 - Active Grill shutter kit.
1 - Coolant bypass hose.
You will need to drain out all coolant from your install. So please have Extra coolant and added oil ready for once all done.
59,000 dtu cooler unit
DOSE NOT WORK FOR THE JEEP MODEL ECO!
As Always This is a Built to order Custom Product! This follows all of our terms. Some models will all perform different just all from set ups. This product works as stated.
Other oil coolers might be needed. per set up can be different.
2 Reviews Hide Reviews Show Reviews
Haven't had a chance to install yet. However the quality is top notch and all pieces and parts look great!
Easy. to install and quality product. Temps have been lower by about 10 degrees on average for unloaded trips so far. It does dump a little heat into the IC so I'm looking to move it behind the CFT IC in the next week.